Yeoman and servicing Bedienungsanleitung PDF herunterladen (Seite 10)

Control Knob

Setting

Indicator

5.23 The exact setting of the thermostat and the Manual Air

Controls may need slight adjustment by trial and error to suit

requirements.

Operate the follow controls manually:

Secondary Air Control

Depending on the strength of the flue pull the Secondary

Air Control should be adjusted so that air from the air inlets

ignite unburnt smoke and flames are visible, but not so

strong that flames reach the glass.

Primary Air Control

Small amounts of Primary Air can sometimes help to

maintain a hot fuel bed and boost hot water output.

Airwash Control

Opening the Airwash Control will increase the visual flame.

Do not burn large amounts of fuel with the Airwash

Control closed for long periods of time. This reduces the

glass cleaning effect of the Airwash and causes tars and

creosotes to build-up in the appliance and flue system.

5.24 Experience establishes settings to suit personal preference.

Over-firing

5.25 When in use, burning the appliance at a high temperature

for a short period reduces tars and creosotes.

DO NOT OPERATE THE APPLIANCE WITH THE PRIMARY

AIR CONTROL OPEN FOR LONG PERIODS OF TIME AS

THISCOULDCAUSEOVER-FIRINGANDMAYCAUSE

PERMANENT DAMAGE.

Shut Down

5.26 If there is still burning fuel in the firebox, Stovax do not

recommend shutting down the air controls completely

unless there is a chimney fire in progress (see section 10

for advice). Closing the controls during the burning process

will cause poor combustion and could lead to a build up of

gasses that could ignite dangerously.

5.27 Always have enough air entering the appliance to maintain

some flame within the firebox.

5.28 If it is necessary to shut down the appliance then run on a

high setting until all of the fuel has been burnt before closing

the air controls.

User Instructions

6. Woodburning Tray

In order to burn wood continuously in a Multi-fuel appliance

a Woodburning Tray must be fitted.

For details on purchasing a Woodburning Kit for this

appliance contact your retailer.

Front edge

6.1 Remove the riddling mechanism from the appliance

(see Pre-Installation, Section 6).

To fit the Wood Burning Tray:

6.2 Remove the log guard and ashpan

6.3 Hold the tray flat with the front edge pointing forwards, tilt

diagonally and insert through the front of the appliance,

see Diagram 14.

Ensure that the lower log guard support is inserted first to

achieve the correct angle.

Log guard

support

6.4 Place tray flat on the fixings on the firebed, see Diagram 15.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 43 44

Kommentare zu diesen Handbüchern

Keine Kommentare

Yeoman and servicing Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Herde Yeoman and servicing