30
If there are any difficulties achieving pairing ensure that
the handset is set to Channel A. To do this follow the
steps below:
2.8 Press the On/Off button (�) for at least 10 seconds. The
LED will flash on and off as normal during this time. When
the LED on the control lights up for at least 1 second
release the button.
2.9 Within 5 seconds of the LED going out press the OK button
and then press the () button.
2.10 Disconnect the batteries from the control box and
reconnect after 10 seconds. The handset will now be set to
Channel A.
2.11 Attempt the pairing again following the steps below:
NOTE: These steps differ from the previous.
2.12 Press the On/Off button (�) for at least 10 seconds. The
LED will flash on and off as normal during this time. When
the LED on the control lights up for at least 1 second
release the button.
2.13 Within 5 seconds of the LED going out press the () button
followed directly by the () button.
2.14 Disconnect the battery pack from the control box and
reconnect after 10 seconds.
2.15 The motor on the valve will turn. Once it has stopped
repeatedly press and release the yellow button on the
control box until the control box beeps to confirm the
pairing operation has been successful.
3. CHANGING COMMUNICATION
CHANNEL
3.1 Press the On/Off button (�) for at least 10 seconds. The
LED will flash on and off as normal during this time. When
the LED on the control lights up for at least 1 second
release the button.
3.2 Within 5 seconds of the LED going out press the OK button.
3.3 Use the UP () and DOWN () buttons to select a new
communication channel. Assuming the appliance is set to
Channel A press the UP () button once to select Channel
B, and again to select Channel C. From Channel C press the
DOWN () button once to select Channel B, and again to
select Channel A.
3.4 Once the chosen channel has been selected disconnect the
battery pack from the control box and reconnect after 10
seconds. This completes the channel change.
3.5 To reset the communication channel to Channel A press the
On/Off button (�) for at least 10 seconds. The LED will
flash on and off as normal during this time. When the LED
on the control lights up for at least 1 second release the
button.
3.6 Within 5 seconds of the LED going out press the OK button.
Do not give any further commands for at least 10
seconds.
3.7 To return to normal operating mode wait for at least 5
seconds or press the On/Off button (�) once.
INSTALLATION INSTRUCTIONS
COMMISSIONING
(48 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern