5
USER INSTRUCTIONS
2.1 To light the appliance using the remote handset press the
On/Off (�) button followed directly by the OK button. The
appliance will emit a beep to confirm the order has been
received and the LED on the handset will briefly illuminate.
After the start up cycle has completed the appliance will
light on the high flame setting (this can take up to 20
seconds).
To decrease the flame height:
2.2 From the high flame setting press the DOWN () button
once to lower the flame to the medium setting.
Each time a command from the handset is received by
the appliance a beep will be emitted and the LED on the
handset will briefly illuminate.
NOTE: In normal operating mode the LED on the remote
control will flash approximately every 4 seconds to show
that it is in communication with the appliance. After each
command has been accepted the LED will cease flashing
until the command has been carried out. Wait until the
LED resumes flashing before giving another command.
2.3 From the medium flame setting press the DOWN ()
button once to lower the flame to the low setting.
2.4 From the low flame setting press the DOWN () button
once to put the appliance in Standby mode (Pilot only).
To increase the flame height:
2.5 To light the appliance when it is in Standby mode press the
UP () button once. The appliance will light on the high
flame setting.
2.6 From the low setting press the UP () button once to
increase the flame setting to medium.
2.7 From the medium setting press the UP () button once to
increase the flame setting to high.
BATTERIES
2.8 The remote handset contains 2 x AA 1.5v alkaline batteries.
Replace exhausted batteries like for like (use high quality
batteries, Duracell or similar). DO NOT USE
RECHARGEABLE BATTERIES.
2.9 Communication between the handset and the appliance
may take up to 2 mins after batteries have been replaced.
2.10 If communication is not regained after this time the control
unit and the handset may need pairing. Please refer to
Commissioning, Section 2, Pairing Handset on page 29.
2B. OPERATING THE APPLIANCE TOUCH
PAD CONTROL
TOUCH PAD CONTROL
The touch pad control is located at the base of the front of
the appliance (see Diagram 2).
2
AR2698
Touch pad
2.11 To light the appliance press the On/Off button once. The
appliance will emit a beep to confirm the order has been
received and the LED on the touch pad will briefly
illuminate.
After the start up cycle has completed the appliance will
light on the high flame setting (this can take up to 20
seconds). A second beep and flash of the touch pad LED
will confirm the command has been carried out.
To decrease the flame height:
2.12 From the high flame setting press the DOWN () button
once to lower the flame to the medium setting.
Each time a command from the touch pad is received by
the appliance a beep will be emitted and the LED on the
touch pad will briefly illuminate. A second beep and
flash of the touch pad LED will confirm the command
has been carried out. Wait for this confirmation before
giving another command.
2.13 From the medium flame setting press the DOWN ()
button once to lower the flame to the low setting.
2.14 From the low flame setting press the DOWN () button
once to put the appliance in Standby mode (Pilot only).
To increase the flame height:
2.15 To light the appliance when it is in Standby mode press the
UP (w) button once. The appliance will light on the high
flame setting.
(48 Seiten)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern